Condence Easy – after installation

Table of Content

After you have physically installed Condence Easy sensors on your target, there are still a few things to do.

It is crucial to know which sensors are attached to which device and what part they are installed in. To ensure that you get the right metrics from the target, get the serial numberS/N – from the attached Treon sensor and location, and inform them to Distence ltd.

Send the serial number and the sensor’s location to the email address operations@distence.fi.

Sensor. S/N is located on the bottom half of the picture.

Configurations are done manually on the Distence ltd side, so to get a visual of the metrics, these steps are needed to be done.

In short

  1. Make physical installation
  2. Write down locations and serial numbers of Condence Easy sensors
  3. Forward the information above to Distence ltd